M25, 4 Pin IP68 Inline Cable Connector, 10–14 mm Cable, Lever Clamp Set

M25 4-pole inline cable joint for joining two cables with an outer diameter of 10–14 mm. Lever-operated spring-clamp wiring and threaded housing sections allow field assembly. Select the cable sealing range and pole count to suit the installation.

Included in each set

One complete inline connector assembly with a 4-pole terminal insert, two housing sections, two cable gland nuts, and the matching sealing and clamping parts. Cables and installation tools are excluded. A quantity option counts complete connector assemblies.

Specifications

Installation

1. Disconnect the power supply and confirm the selected seal matches the complete cable jacket diameter.
2. Pass each cable through its gland nut, seal and clamping parts before connecting the conductors.
3. Connect the conductors to the corresponding lever-clamp terminals. Open the corresponding lever, insert the conductor, and close the lever securely. Follow the markings on the supplied insert and keep exposed strands within the terminal.
4. Seat the seals and clamping parts correctly, close the housing sections and tighten the cable glands around the jackets.
5. Check conductor retention and continuity before energizing. Verify the completed installation is suitable for the environment.

Quantity options

Choose 1, 10, 50 complete sets. Each set has the same pole count and selected cable seal range.

Selection notes

The cable range refers to the outside diameter of the insulated cable jacket. Confirm conductor type, conductor cross-section and electrical requirements before ordering. IP68 is the supplier protection designation for correct assembly. M16, M20 and M25 identify the supplied connector series. Refer to the matched drawing or supplier size reference for assembly dimensions.